Ghost Controls Keypad & Intercom Repair Nationwide

Ghost Controls Keypad & Intercom Repair: The Tarzana Owner’s Guide

Ghost Controls keypad and intercom repair in Tarzana typically runs $220 to $460 installed, depending on whether we’re replacing a keypad, an intercom module, or the wiring between them. We keep Ghost Controls-compatible keypads and intercom parts on our trucks, so most repairs are completed in a single visit. You’ll usually discover the failure when the keypad stops accepting your code, the intercom goes silent on one end, or the gate opens fine from the remote but not from the keypad.

Call (925) 263-6107

We’re an independent gate service company, not affiliated with Ghost Controls. That independence works in your favor: we’re not tied to a factory parts pipeline, and we stock both OEM Ghost Controls parts and quality aftermarket equivalents that match or beat the original spec. Victor Salinas and our technicians have repaired Ghost Controls keypads and intercoms across Tarzana, Encino, Woodland Hills, and the wider West Valley for years. A gate should open when you want it to and stay closed when you don’t. Everything else is just keeping that promise.

Which Ghost Controls Models This Applies To

Ghost Controls builds residential gate openers sold under a few version names: the TSS1, TDS2, TSS1XP, and the newer wireless keypad line that pairs with their XP and non-XP control boards. The keypad compatibility question comes down to two things: whether your Ghost Controls board has a wired keypad terminal or is wireless-only, and which radio frequency your receiver uses. Older Ghost Controls keypads from the early 2010s ran on a 318 MHz receiver. The current XP series runs on a different frequency and will not pair with those older keypads. If you bought your gate opener before about 2015, that’s the gotcha most Tarzana homeowners hit when they order a replacement keypad online and it simply will not sync.

Here’s what matters for the OEM versus aftermarket decision. Ghost Controls OEM keypads are reliable but expensive relative to what’s inside them: a sealed membrane, a small board, and a radio transmitter. Quality aftermarket keypads from brands we vet carefully replicate the same frequency and code format at 30 to 40 percent less, and in our experience they hold up as well or better in Tarzana’s dry heat. The intercom side is different. Ghost Controls intercom modules are less broadly aftermarket-supported, so we usually install OEM there. Bring us the model number from your keypad’s back plate or the label on your control board, and we’ll match the right part before we arrive.

Signs Your Ghost Controls Keypad or Intercom Is Failing

• Keypad accepts the code but the gate doesn’t move. This usually means the keypad is transmitting, but the receiver board isn’t hearing it. It can be a dead keypad battery, but just as often it’s corrosion on the control board terminals or a receiver that’s lost its programming in a power surge.
• Keypad beeps but won’t accept any code. The membrane is shot or the keypad’s internal memory cleared. Tarzana’s summer heat, with surface temperatures over 120 degrees on a metal gate post, cooks these membranes faster than the manufacturer expects.
• Intercom works one way but not the other. You hear the visitor, but they can’t hear you, or vice versa. That’s almost always a failed speaker lead or microphone contact inside the intercom module, not the wiring.
• Gate opens on its own or won’t close after a keypad entry. This points to the keypad sending a stuck signal, or worse, a short in the wiring run between the keypad and the board. If the gate is doing anything unpredictable with a keypad wired into it, cut power to the opener and call us.
• The keypad works sometimes, fails other times. Loose or oxidized wire connections at the board, or a keypad housing that’s cracked and letting morning dew in. Tarzana gets little rain, but condensation cycles from cool nights to hot days are exactly what corrodes these connections over two or three years.

What a Ghost Controls Keypad or Intercom Replacement Costs in Tarzana

Most Ghost Controls keypad replacements we install in Tarzana run between $220 and $340, parts and labor included. A Ghost Controls intercom module replacement lands between $300 and $460. If we’re replacing both at the same time, the range is $450 to $600 because we’re already on site and doing the wiring once instead of twice. What moves the number is whether you need a wired keypad or a wireless one, whether your existing wiring is reusable or needs to be re-pulled, and whether the intercom runs on the same wire run or needs its own.

Here’s how the parts and labor usually break down:

• Ghost Controls-compatible keypad (aftermarket): $80 to $140
• Ghost Controls OEM keypad: $130 to $190
• Ghost Controls intercom module: $170 to $270
• Labor, testing, and programming: $110 to $160 flat
• Rewiring between keypad or intercom and board (if needed): $60 to $100

You get a firm quote before a single bolt is turned. We don’t install anything, then hand you a bigger bill. The price we agree on is the price you pay. Every repair, including the keypad and intercom work, carries our 90-Day Done Right Promise in writing: if it isn’t right, we come back and make it right. No arguing. That’s the Keystone Standard on every job we finish.

DIY or Call Us?

There are two things a Tarzana owner can safely check before calling us, and they solve about ten percent of keypad “dead” calls. One: replace the keypad battery. Ghost Controls keypads run on a 9-volt or AA batteries depending on the model, and a weak battery makes the keypad behave exactly like a broken one. Two: look at the keypad face. If the plastic face is cracked or the membrane looks swollen from the heat, that keypad is compromised and needs replacement regardless of what the battery says.

Past that, we’d tell you to stop. Ghost Controls keypads and intercoms wire into the control board terminals, and the wrong connection or a shorted wire can take out the board itself. A Ghost Controls control board runs $300 to $500 as a repair, so the false economy of guessing at wiring is real. Also: your gate motor moves hundreds of pounds. If the keypad or intercom is doing anything unpredictable with gate behavior, one wrong move can pin a hand or worse. We’re background-checked, uniformed, and trained across nine gate brands including Ghost Controls. Call us at (925) 263-6107 and we’ll have someone look at it, usually same day.

FAQs